Configuring Power Over Ethernet (Poe) - Enterasys Matrix 2G4072-52 Configuration Manual

2.2.5

Configuring Power over Ethernet (PoE)

This section applies only to PoE-equipped Matrix devices. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.
Purpose
To review and set PoE parameters, including the power available to the chassis, the usage threshold
for each module, whether or not SNMP trap messages will be sent when power status changes, and
per-port PoE settings.
Commands
The commands used to review and set PoE port parameters are listed below and described in the
associated section as shown.
•
show inlinepower
•
set inlinepower mode
•
clear inlinepower mode
•
set inlinepower available
•
clear inlinepower available
•
set inlinepower powertrap
•
clear inlinepower powertrap
•
set inlinepower assigned
•
clear inlinepower assigned
•
set inlinepower threshold
•
clear inlinepower threshold
•
set inlinepower management
•
clear inlinepower management
•
set inlinepower psetrap
•
clear inlinepower psetrap
•
show port inlinepower
Important Notice
(Section 2.2.5.1)
(Section 2.2.5.2)
(Section 2.2.5.3)
(Section 2.2.5.4)
(Section 2.2.5.5)
(Section 2.2.5.6)
(Section 2.2.5.7)
(Section 2.2.5.8)
(Section 2.2.5.9)
(Section 2.2.5.10)
(Section 2.2.5.11)
(Section
(Section
(Section 2.2.5.14)
(Section 2.2.5.15)
(Section 2.2.5.16)
Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.5.12)
2.2.5.13)
General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-95