Configuring Power Over Ethernet (Poe); Purpose; Commands; Show Inlinepower - Enterasys SecureStack C2 Configuration Manual

Configuring Power over Ethernet (PoE)

This section applies only to PoE-equipped SecureStack C2 devices. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.

Purpose

To review and set PoE parameters, including the power available to the system, the usage
threshold for each module, whether or not SNMP trap messages will be sent when power status
changes, and per‐port PoE settings.

Commands

The commands used to review and set PoE port parameters are listed below.
For information about...

show inlinepower

set inlinepower threshold
set inlinepower trap
show port inlinepower
set port inlinepower
show inlinepower
Use this command to display switch PoE properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Important Notice
Configuring Power over Ethernet (PoE)
Refer to page...
3-27
3-28
3-28
3-29
3-29
SecureStack C2 Configuration Guide 3-27