Set System Location; Set System Contact - Enterasys SECURESTACK C3 Configuration Manual

set system location

set system location
Use this command to identify the location of the system.
Syntax
set system location [string]
Parameters
string
Defaults
If string is not specified, the location name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system location string:
C3(su)->set system location "Bldg N32-04 Closet 9"

set system contact

Use this command to identify a contact person for the system.
Syntax
set system contact [string]
Parameters
string
Defaults
If string is not specified, the contact name will be cleared.
Mode
Switch command, read‐write.
3-28 Basic Configuration
(Optional) Specifies a text string that indicates where the system is
located.
Note: A location string containing a space in the text must be
enclosed in quotes as shown in the example below.
(Optional) Specifies a text string that contains the name of the person to
contact for system administration.
Note: A contact string containing a space in the text must be enclosed
in quotes as shown in the example below.