Clear Port Priority-Queue; Configuring Quality Of Service (Qos); Purpose; Commands - Enterasys SecureStack C2 Configuration Manual

clear port priority-queue

Example
This example shows how to set priority 5 frames received on
C2(su)->set port priority-queue ge.2.12 5 0
clear port priority-queue
Use this command to reset port priority queue settings back to defaults for one or more ports.
Syntax
clear port priority-queue port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the priority queue settings on
C2(su)->clear port priority-queue ge.2.12

Configuring Quality of Service (QoS)

Purpose

Eight transmit queues are implemented in the switch hardware for each port, but only six are
available for use in prioritizing various data and control traffic. The seventh and eighth queues are
reserved for stacking (if applicable) and network control related communications.
The commands in this section allow you to set the priority mode and weight for each of the
available six queues (queues 0 through 5) for each physical port on the switch. Priority mode and
weight cannot be configured on LAGs, only on the physical ports that make up the LAG.

Commands

For information about...
show port txq
set port txq
clear port txq
10-6 Port Priority and Rate Limiting Configuration
Specifies the port for which to clear priority‐to‐queue mappings. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.
.2.12 to transmit on queue 0.
ge
.2.12:
ge
Refer to page...
10-7
10-7
10-8