Router Vrrp - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.6.1

router vrrp

Use this command to enable or disable VRRP configuration mode.
router vrrp
NOTE: You must execute the router vrrp command to enable the protocol before
completing other VRRP-specific configuration tasks. For details on enabling
configuration modes, refer to
Syntax Description
None.
Command Syntax of the "no" Form
The "no" form of this command removes all VRRP configurations from the
running configuration:
no router vrrp
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how enable VRRP configuration mode:
Matrix>Router1#configure terminal
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#
Table 2-9 in Section
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
2.3.3.
Configuring VRRP
13-91