For information about...
preempt
enable
show ip vrrp
router vrrp
Use this command to enable or disable VRRP configuration mode. The no form of this command
removes all VRRP configurations from the running configuration.
Syntax
router vrrp
no router vrrp
Parameters
None.
Defaults
None.
Mode
Global configuration: C2(su)‐>router(Config)#
Usage
You must execute the router vrrp command to enable the protocol before completing other
VRRP‐specific configuration tasks. For details on enabling configuration modes, refer to
Table
15‐2 in "Enabling Router Configuration Modes" on page 15‐2.
Example
This example shows how enable VRRP configuration mode:
C2(su)->router#configure
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#
create
Use this command to create a VRRP session. Each SecureStack C2 system supports up to 20 VRRP
sessions. The no form of this command disables the VRRP session.
Syntax
create vlan vlan-id vrid
no create vlan vlan-id vrid
Refer to page...
17-42
17-43
17-44
SecureStack C2 Configuration Guide 17-39
router vrrp