Configuring Ospf; Ospf Configuration Task List And Commands - Enterasys SecureStack C2 Configuration Manual

Configuring OSPF

Example
This example shows how to redistribute routing information discovered through static routes will
be redistributed into RIP update messages:
C2(su)->router(Config)#router rip
C2(su)->router(Config-router)#redistribute static
Configuring OSPF
OSPF is an advanced routing feature that must be enabled with a license key. If you have purchased an
advanced license key, and have enabled routing on the device, you must activate your license as described
in "Activating Licensed
purchase an advanced routing license, contact Enterasys Networks Sales.
Purpose
To enable and configure the Open Shortest Path First (OSPF) routing protocol.

OSPF Configuration Task List and Commands

Table 17‐2 lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
Table 17-2 OSPF Configuration Task List and Commands
To do this...
If necessary, activate your advanced routing
license.
Enable OSPF configuration mode.
Enable or disable RFC 1583 compatibility.
Configure OSPF Interface Parameters.
Enable OSPF on the interface.
Configure an OSPF area.
• Set the cost of sending a packet on an
OSPF interface.
• Set a priority to help determine the OSPF
designated router for the network.
• Adjust timers and message intervals.
17-10 IPv4 Routing Protocol Configuration
* Advanced License Required *
Features" on page 15-3 in order to enable the OSPF command set. If you wish to
Use these commands...
See "Activating Licensed Features" on page 15-3.
"router id" on page 17-11
"router ospf" on page 17-12
"1583compatibility" on page 17-12
"ip ospf enable" on page 17-13
"ip ospf areaid" on page 17-13
"ip ospf cost" on page 17-14
"ip ospf priority" on page 17-14
"timers spf" on page 17-15
"ip ospf retransmit-interval" on page 17-16
"ip ospf transmit-delay" on page 17-16
"ip ospf hello-interval" on page 17-17
"ip ospf dead-interval" on page 17-17