Ip Rip Send Version - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.2.7

ip rip send version

Use this command to set the RIP version(s) for update packets transmitted on an interface.
ip rip send version {1 | 2 | r1compatible}
Syntax Description
1
2
r1compatible
Command Syntax of the "no" Form
The "no" form of this command restores the version of update packets that was
transmitted by the RIP module:
no ip rip send version
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the RIP send version to 2 for packets transmitted on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip send version 2
Specifies RIP version 1.
Specifies RIP version 2.
Specifies that packets be sent as version 2 packets, but
transmits these as broadcast packets rather than multicast
packets so that systems which only understand RIP version
1 can receive them.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring RIP
13-11