Clear Dhcp Pool Client-Identifier; Set Dhcp Pool Client-Name - Enterasys SecureStack C2 Configuration Manual

clear dhcp pool client-identifier

Example
This example shows how to configure the minimum requirements for a manual binding address
pool, using a client identifier rather than the hardware address of the client's hardware platform.
C2(rw)->set dhcp pool manual2 client-identifier 01:00:01:22:33:44:55
C2(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
clear dhcp pool client-identifier
Use this command to remove the unique identifier of a DHCP client from a manual binding
address pool.
Syntax
clear dhcp pool poolname client-identifier
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the client identifier from the address pool named "manual1."
C2(rw)->clear dhcp pool manual1 client-identifier

set dhcp pool client-name

Use this command to assign a name to a DHCP client when creating an address pool for manual
binding.
Syntax
set dhcp pool poolname client-name name
Parameters
poolname
name
Defaults
None.
14-18 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name to be assigned to this client. Client names may be up to
31 characters in length.