Set Cdp State; Set Cdp Auth - Enterasys SecureStack C2 Configuration Manual

Table 4-1 show cdp Output Details (Continued)
Output
CDP Transmit
Frequency
Port
Status

set cdp state

Use this command to enable or disable the CDP discovery protocol on one or more ports.
Syntax
set cdp state {auto | disable | enable} [port-string]
Parameters
auto | disable |
enable
port‐string
Defaults
If port‐string is not specified, the CDP state will be globally set.
Mode
Switch command, read‐write.
Examples
This example shows how to globally enable CDP:
C2(su)->set cdp state enable
This example shows how to enable the CDP for port
C2(su)->set cdp state enable ge.1.2
This example shows how to disable the CDP for port
C2(su)->set cdp state disable ge.1.2

set cdp auth

Use this command to set a global CDP authentication code.
What It Displays...
Frequency (in seconds) at which CDP messages can be transmitted. The default of
60 seconds can be reset with the set cdp interval command. For details, refer to
cdp interval" on page 4-4.
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Whether CDP is enabled, disabled or auto-enabled on the port.
Auto‐enables, disables or enables the CDP protocol on the specified port(s).
In auto‐enable mode, which is the default mode for all ports, a port
automatically becomes CDP‐enabled upon receiving its first CDP message.
(Optional) Enables or disables CDP on specific port(s). For a detailed
description of possible port‐string values, refer to
" on page 5‐2.
the CLI
CLI" on page 5-2.
"Port String Syntax Used in
.1.2:
ge
.1.2:
ge
SecureStack C2 Configuration Guide 4-3
set cdp state
"set