This chapter provides information concerning the following:
For information about...
Using LANVIEW
Troubleshooting Checklist
Overview of DFE Module Shutdown Procedure
Recommended Shutdown Procedure Using OFFLINE/RESET Switch
Last Resort Shutdown Procedure Using OFFLINE/RESET Switch
Using LANVIEW
The DFE module uses a built‐in visual diagnostic and status monitoring system called
LANVIEW. The LANVIEW LEDs (Figure
status to aid in diagnosing network problems.
About the Management (MGMT) LED
The MGMT LED (shown in Figure
Management Module to control the management functions for all DFE modules in the
chassis. The Management Module handles all IP requests to the chassis IP address, such
as, but not limited to, PING, Telnet, SNMP, HTTP. The Management Module also handles
the CLI configuration sessions through the console port. So, when you plug into a DFE
module COM port to configure a DFE module in the chassis, it is handled by the
Management Module regardless of the DFE module COM port that you use.
Troubleshooting
4‐1) allow quick observation of the network
4‐1) indicates when the module is serving as the
DFE-Platinum Series Hardware Installation Guide 4-1
4
Refer to page...
4-1
4-6
4-8
4-9
4-10