Show Interface - Enterasys SecureStack C2 Configuration Manual

show interface

show interface
Use this command to display information about one or more interfaces (VLANs or loopbacks)
configured on the router.
Syntax
show interface [vlan vlan-id] [loopback loop-id]
Parameters
vlan vlan‐id
loopback loop‐id
Defaults
If interface type is not specified, information for all routing interfaces will be displayed.
Mode
Any router mode.
Examples
This example shows how to display information for all interfaces configured on the router. For a
detailed description of this output, refer to Table
C2(su)->router#show interface
Vlan 1 is Administratively DOWN
Vlan 1 is Operationally DOWN
Mac Address is: 0001.f4da.2cba
The name of this device is Vlan 1
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
This example shows how to display information for loopback interface 1.
C2(su)->router#show interface loopback 1
Loopback 1 is Administratively UP
Loopback 1 is Operationally UP
Internet Address is 10.1.192.100, Subnet Mask is 255.255.255.0
The name of this device is Loopback 1
The MTU is 1500 bytes
interface
Use this command to configure interfaces for IP routing.
Syntax
interface vlan vlan-id | loopback loop-id
16-2 IP Configuration
(Optional) Displays interface information for a specific VLAN interface.
This interface must be configured for IP routing as described in "Pre‐
Routing Configuration Tasks" on page 15‐1.
(Optional) Displays interface information for a specific loopback interface.
16‐1: