Show Interface; Interface - Enterasys SecureStack B3 Configuration Manual

show interface

show interface
Use this command to display information about one or more interfaces (VLANs or loopbacks)
configured on the router.
Syntax
show interface [vlan vlan-id]
Parameters
vlan vlan‐id
Defaults
If interface type is not specified, information for all routing interfaces will be displayed.
Mode
Any router mode.
Examples
This example shows how to display information for all interfaces configured on the router. For a
detailed description of this output, refer to Table
B3(su)->router#show interface
Vlan 1 is Administratively DOWN
Vlan 1 is Operationally DOWN
Mac Address is: 0001.f4da.2cba
The name of this device is Vlan 1
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds

interface

Use this command to configure interfaces for IP routing.
Syntax
interface vlan vlan-id
Parameters
vlan vlan‐id
Defaults
None.
17-2 IP Configuration
(Optional) Displays interface information for a specific VLAN interface.
This interface must be configured for IP routing as described in "Pre‐
Routing Configuration Tasks" on page 16‐1.
Specifies the number of the VLAN interface to be configured for routing.
This interface must be configured for IP routing as described in "Pre‐
Routing Configuration Tasks" on page 16‐1.
17‐1: