Clear Nodealias Config - Enterasys Matrix 2G4072-52 Configuration Manual

11.2.7.8

clear nodealias config

Use this command to reset node alias state to enabled and clear the maximum entries value.
clear nodealias config port-string
Syntax Description
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the node alias configuration on fe.1.3
Matrix(rw)->clear nodealias config fe.1.3
Specifies the port(s) on which to reset the node alias
configuration. For a detailed description of possible
port-string values, refer to
Matrix DFE-Platinum and Diamond Series Configuration Guide
Logging And Network Management Command Set
Section
:
Configuring Node Aliases
4.1.1.
11-151