Show Rmon Filter; Set Rmon Filter - Enterasys SecureStack B3 Configuration Manual

show rmon filter

Use this command to display one or more RMON filter entries.
Syntax
show rmon filter [index index | channel channel]
Parameters
index index |
channel channel
Defaults
If no options are specified, information for all filter entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display all RMON filter entries and channel information:
B3(rw)->show rmon filter
Index= 55508
----------------------------------------------------------
Data Offset
PktStatusMask
Owner
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00

set rmon filter

Use this command to configure an RMON filter entry.
Syntax
set rmon filter index channel-index [offset offset] [status status] [smask smask]
[snotmask snotmask] [data data] [dmask dmask] [dnotmask dnotmask] [owner owner]
Parameters
index
channel‐index
(Optional) Displays information about a specific filter entry, or about all
filters which belong to a specific channel.
Channel Index= 628
0 PktStatus
0 PktStatusNotMask
ETS,NAC-D
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 10. Maximum value is 65535.
Specifies the channel to which this filter will be applied.
EntryStatus= valid
0
0
SecureStack B3 Configuration Guide 14-17
show rmon filter