Parameters
port‐string
sid sid
Defaults
If no port‐string is specified, status is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐only.
Example
This example shows how to display Loop Protect status on
B3(su)->show spantree lp port ge.2.3
LoopProtect is disabled on port ge.2.3
clear spantree lp
Use this command to return the Loop Protect status per port and optionally, per SID, to its default
state of disabled.
Syntax
clear spantree lp port-string [sid sid]
Parameters
port‐string
sid sid
Defaults
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐write.
Example
This example shows how to return the Loop Protect state on
B3(rw)->clear spantree lp port ge.2.3
(Optional) Specifies port(s) for which to display the Loop Protect
feature status.
(Optional) Specifies the specific Spanning Tree(s) for which to display
the Loop Protect feature status. Valid values are 0 ‐ 4094. If not
specified, SID 0 is assumed.
Specifies port(s) for which to clear the Loop Protect feature status.
(Optional) Specifies the specific Spanning Tree(s) for which to clear the
Loop Protect feature status. Valid values are 0 ‐ 4094. If not specified,
SID 0 is assumed.
.2.3:
ge
, SI
.2.3 to disabled:
ge
SecureStack B3 Configuration Guide 7-41
clear spantree lp