Show Snmp Notifyprofile; Set Snmp Notifyprofile - Enterasys SECURESTACK C3 Configuration Manual

show snmp notifyprofile

show snmp notifyprofile
Use this command to display SNMP notify profile information. This associates target parameters
to an SNMP notify filter to determine who should not receive SNMP notifications.
Syntax
show snmp notifyprofile [profile] [targetparam targetparam] [volatile |
nonvolatile | read-only]
Parameters
profile
targetparam
targetparam
volatile |
nonvolatile | read‐
only
Defaults
If no parameters are specified, all notify profile information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display SNMP notify information for the profile named "area51":
C3(su)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile
TargetParam
Storage type
Row status

set snmp notifyprofile

Use this command to create an SNMP notify filter profile configuration. This associates a
notification filter, created with the set snmp notifyfilter command ("set snmp notifyfilter" on
page 8‐34), to a set of SNMP target parameters to determine which management targets should
not receive SNMP notifications.
Syntax
set snmp notifyprofile profile targetparam targetparam [volatile | nonvolatile]
8-36 SNMP Configuration
(Optional) Displays a specific notify profile.
(Optional) Displays entries for a specific target parameter.
(Optional) Displays notify filter entries of a specific storage type.
= area51
= v3ExampleParams
= nonVolatile
= active