Starting And Configuring Telnet; Purpose; Commands; Show Telnet - Enterasys SECURESTACK C3 Configuration Manual

Starting and Configuring Telnet

Purpose

To enable or disable Telnet, and to start a Telnet session to a remote host. The SecureStack C3
switch allows a total of four inbound and / or outbound Telnet session to run simultaneously.

Commands

For information about...

show telnet

set telnet

telnet
show telnet
Use this command to display the status of Telnet on the switch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display Telnet status:
C3(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
Use this command to enable or disable Telnet on the switch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Starting and Configuring Telnet
Refer to page...
3-37
3-37
3-38
SecureStack C3 Configuration Guide 3-37