General Configuration Command Set
Starting and Configuring Telnet
2.2.8.2
set telnet
Use this command to enable or disable Telnet on the device.
set telnet {enable | disable}{inbound | outbound | all}
Syntax Description
enable | disable
inbound |
outbound | all
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable inbound and outbound Telnet services:
Matrix(rw)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
2-124 Matrix DFE-Platinum and Diamond Series Configuration Guide
Enables or disables Telnet services.
Specifies inbound service (the ability to Telnet to this
device), outbound service (the ability to Telnet to other
devices), or all (both inbound and outbound).