Ip Inactivity-Timer - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ip inactivity-timer

Syntax
Release Information
Description
Options
Mode
836
[ no ] ip inactivity-timer inactiveTime
Command introduced before JunosE Release 7.1.0.
Configures an inactivity timer. IP polls the dynamic interface at the configured interval
to determine whether the interface was active during the interval. Inactive interfaces are
deleted only when the period of inactivity is equal to or greater than the configured value.
The no version disables the timer.
inactiveTime—Length of time in the range 0–63335 minutes; a value of 0 specifies that
dynamically created subscriber interfaces are not deleted
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.