Clear Ip Ospf Neighbor - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

clear ip ospf neighbor

clear ip ospf neighbor [ neighborAddress ]
Syntax
Command introduced in JUNOSe Release 7.1.0.
Release Information
Clears or resets adjacency with a specified neighbor session. There is no no version.
Description
NOTE: When OSPF is configured and running over an NBMA network, do not issue
the clear ip ospf neighbor command simultaneously on both ends of the OSPF link.
Doing so brings the OSPF link down completely. In this event, you must do one of
the following on both sides of the link to bring the link back up:
Options
Privileged Exec
Mode
396
clear ip ospf neighbor
Reconfigure the OSPF neighbors on the NBMA interface with the neighbor
command.
Issue the clear ip ospf database command to clear and reset the OSPF
adjacencies.
Issue the shutdown command followed by the no shutdown command on the
interface.
neighborAddress IP address of identified neighbor to clear or reset