Clear Bgp Ipv6 Wait-End-Of-Rib - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

clear bgp ipv6 wait-end-of-rib

clear bgp ipv6 [ unicast | multicast | vpnv6 | route-target signaling ] [ vrf vrfName ]
Syntax
[ ipAddress | ipv6Address | peer-group peerGroupName | * ] wait-end-of-rib
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
route-target signaling keywords added in JUNOSe Release 8.2.0.
Resets the IPv6 BGP session and brings down the underlying TCP connection and
Description
then brings it back up again, causing both peers to resend their complete BGP routing
table. Clears the specified peer from the set of peers for which BGP is waiting to
receive an End-of-RIB marker after a peer restart. Hard clearing a peer has the same
effect for that peer. There is no no version.
Options
Privileged Exec
Mode
unicast Clears the unicast routing table; the default option
multicast—Clears the multicast routing table
vpnv6 —Clears the VPNv6 unicast routing and forwarding table
route-target signaling Clears the route-target membership information
vrfName Name of a virtual routing and forwarding instance to clear
ipAddress IP address of identified BGP neighbor to clear
ipv6Address IPv6 address of identified BGP neighbor to clear
peerGroupName Name of a BGP peer group to clear
* Clears all connections
Chapter 4: C Commands
clear bgp ipv6 wait-end-of-rib
371