Set Pwa Ipaddress; Set Pwa Protocol - Enterasys SecureStack B3 Configuration Manual

set pwa ipaddress

Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to hide the Enterasys Networks logo:
B3(su)->set pwa displaylogo hide
set pwa ipaddress
Use this command to set the PWA IP address. This is the IP address of the end station from which
PWA will prevent network access until the user is authenticated.
Syntax
set pwa ipaddress ip-address
Parameters
ip‐address
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a PWA IP address of 1.2.3.4:
B3(su)->set pwa ipaddress 1.2.3.4

set pwa protocol

Use this command to set the port web authentication protocol.
Syntax
set pwa protocol {chap | pap}
20-62 Security Configuration
Specifies a globally unique IP address. This same value must be
configured into every authenticating switch in the domain.