No Ip Irdp Multicast - Enterasys Matrix 2G4072-52 Configuration Manual

Routing Protocol Configuration Command Set
Configuring IRDP
13.2.5.7

no ip irdp multicast

Use this command to enable the router to send IRDP advertisements using broadcast rather than
multicast transmissions. By default, the router sends IRDP advertisements via multicast.
no ip irdp multicast
Syntax Description
None.
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable the router to send IRDP advertisements using broadcast:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#no ip irdp multicast
13-88 Matrix DFE-Platinum and Diamond Series Configuration Guide