Show Running-Config; No Shutdown - Enterasys SECURESTACK C3 Configuration Manual

show running-config

Example
This example sets the IP address to 192.168.1.1 and the network mask to 255.255.255.0 for VLAN 1:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip address 192.168.1.1 255.255.255.0
show running-config
Use this command to display the non‐default, user‐supplied commands entered while configuring
the device.
Syntax
show running-config
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display the current router operating configuration:
C3(su)->router#show running-config
!
interface vlan 10
ip address 99.99.2.10 255.255.255.0

no shutdown

!
router ospf 1
network 99.99.2.0
network 192.168.100.1 0.0.0.0
no shutdown
Use this command to enable an interface for IP routing and to allow the interface to automatically
be enabled at device startup.
Syntax
no shutdown
shutdown
Parameters
None.
Defaults
None.
19-6 IP Configuration
0.0.0.255 area 0.0.0.0
area 0.0.0.0