Set Cos Settings - Enterasys SecureStack B3 Configuration Manual

set cos settings

Syntax
clear cos state
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the CoS state back to its default setting of disabled:
B3(su)->clear cos state
set cos settings
Use this command to configure a Class of Service entry in the CoS settings table.
Syntax
set cos settings cos-index priority priority [tos-value tos-value][irl-reference
irl-reference]
Parameters
cos‐index
priority priority
tos‐value tos‐value
irl‐reference
irl‐reference
Defaults
If no optional parameters are specified, none will be applied.
Mode
Switch command, read‐write.
Usage
The CoS settings table takes individual class of service features and displays them as belonging to
a CoS entry. Essentially, it is used for CoS feature assignment. Each class of service entry consists
of an index, 802.1p priority, an optional ToS value, and an IRL reference.
10-20 Policy Classification Configuration
Specifies a Class of Service entry. Valid values are 0 to 255.
Specifies an 802.1d priority value. Valid values are 0 to 7, with 0 being the
lowest priority. See Usage section below for more information.
(Optional) Specifies a Type of Service value. Valid values are 0 to 255. See
Usage section below for more information.
(Optional) Set the inbound rate limiter associated with this entry. Valid
values are 0 to 99. See Usage section below for more information.