Set Port Vlan; Clear Port Vlan - Enterasys SECURESTACK C3 Configuration Manual

ge.2.5 is set to 1
ge.2.6 is set to 1

set port vlan

Use this command to configure the PVID (port VLAN identifier) for one or more ports.
Syntax
set port vlan port-string pvid [modify-egress | no-modify-egress]
Parameters
port‐string
pvid
modify‐egress
no‐modify‐egress (Optional) Does not prompt for or make egress list changes.
Defaults
None.
Mode
Switch command, read‐write.
Usage
The PVID is used to classify untagged frames as they ingress into a given port.
Example
This example shows how to add
C3(su)->set vlan create 4
C3(su)->set port vlan ge.1.10 4 modify-egress

clear port vlan

Use this command to reset a port's 802.1Q port VLAN ID (PVID) to the host VLAN ID 1.
Syntax
clear port vlan port-string
Specifies the port(s) for which to configure a VLAN identifier. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
Specifies the VLAN ID of the VLAN to which port(s) will be added.
(Optional) Adds port(s) to VLANʹs untagged egress list and removes them
from other untagged egress lists.
Note: The following command will reset the specified port's egress status to tagged. To set the
specified ports back to the default egress status of untagged, you must issue the
command as described on page 10-9.
1.10 to the port VLAN list of VLAN 4 (PVID 4).
ge.
set port vlan
SecureStack C3 Configuration Guide 10-9
set port vlan