Set Spantree Protomigration; Show Spantree Spanguard - Enterasys SecureStack C2 Configuration Manual

set spantree protomigration

Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear topology change trap suppression setting:
C2(rw)->clear spantree tctrapsuppress
set spantree protomigration
Use this command to reset the protocol state migration machine for one or more Spanning Tree
ports. When operating in RSTP mode, this forces a port to transmit MSTP BPDUs.
Syntax
set spantree protomigration <port-string>
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the protocol state migration machine on port 20:
C2(su)->set spantree protomigration ge.1.20

show spantree spanguard

Use this command to display the status of the Spanning Tree SpanGuard function.
Syntax
show spantree spanguard
Parameters
None.
7-24 Spanning Tree Configuration
Reset the protocol state migration machine for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.