Commands; Set Spantree Portadmin; Clear Spantree Portadmin - Enterasys SecureStack C2 Configuration Manual

set spantree portadmin

Commands

For information about...
set spantree portadmin

clear spantree portadmin

show spantree portadmin
show spantree portpri
set spantree portpri
clear spantree portpri
show spantree adminpathcost
set spantree adminpathcost
clear spantree adminpathcost
show spantree adminedge
set spantree adminedge
clear spantree adminedge
set spantree portadmin
Use this command to disable or enable the Spanning Tree algorithm on one or more ports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
port‐string
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable Spanning Tree on
C2(rw)->set spantree portadmin ge.1.5 disable
clear spantree portadmin
Use this command to reset the default Spanning Tree admin status to enable on one or more ports.
7-32 Spanning Tree Configuration
Specifies the port(s) for which to enable or disable Spanning Tree. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.
Disables or enables Spanning Tree.
Refer to page...
.1.5:
ge
7-32
7-32
7-33
7-33
7-34
7-35
7-35
7-36
7-36
7-37
7-37
7-38