Clear Spantree Default - Enterasys Matrix 2G4072-52 Configuration Manual

6.2.1.74

clear spantree default

Use this command to restore default values to a Spanning Tree.
clear spantree default [sid]
Syntax Description
sid
Command Defaults
If sid is not specified, defaults will be restored on Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to restore Spanning Tree defaults on SID 1:
Matrix(rw)->
(Optional) Restores defaults on a specific Spanning Tree.
Valid values are 0 - 4094. If not specified, SID 0 is
assumed.
clear spantree default 1
Matrix DFE-Platinum and Diamond Series Configuration Guide
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-87