Show Spantree Spanguard; Set Spantree Spanguard - Enterasys SECURESTACK C3 Configuration Manual

Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the protocol state migration machine on port 20:
C3(su)->set spantree protomigration ge.1.20

show spantree spanguard

Use this command to display the status of the Spanning Tree SpanGuard function.
Syntax
show spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard function status:
C3(su)->show spantree spanguard
Spanguard is disabled

set spantree spanguard

Use this command to enable or disable the Spanning Tree SpanGuard function.
Syntax
set spantree spanguard {enable | disable}
Parameters
enable | disable
Defaults
None.
Enables or disables the SpanGuard function.
show spantree spanguard
SecureStack C3 Configuration Guide 9-25