Clear Spantree Legacypathcost; Show Spantree Autoedge; Set Spantree Autoedge - Enterasys SECURESTACK C3 Configuration Manual

clear spantree legacypathcost

clear spantree legacypathcost
Use this command to set the Spanning Tree default value for legacy path cost to 802.1t values.
Syntax
clear spantree legacypathcost
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the legacy path cost to 802.1t values.
C3(rw)->clear spantree legacypathcost

show spantree autoedge

Use this command to display the status of automatic edge port detection.
Syntax
show spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the status of the automatic edge port detection function:
C3(rw)->show spantree autoedge
autoEdge is currently enabled.

set spantree autoedge

Use this command to enable or disable the automatic edge port detection function.
Syntax
set spantree autoedge {disable | enable}
9-32 Spanning Tree Configuration