Show Spantree Bridgeprioritymode; Set Spantree Bridgeprioritymode - Enterasys SecureStack C2 Configuration Manual

show spantree bridgeprioritymode

Defaults
By default BPDU forwarding is disabled.
Mode
Switch command, read‐write.
Usage
The Spanning Tree protocol must be disabled (set spantree disable) for this feature to take effect.
Example
This example shows how to enable BPDU forwarding:
C2(rw)-> set spantree bpdu-forwarding enable
show spantree bridgeprioritymode
Use this command to display the Spanning Tree bridge priority mode setting.
Syntax
show spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the Spanning Tree bridge priority mode setting:
C2(rw)->show spantree bridgeprioritymode
Bridge Priority Mode is set to IEEE802.1t mode.

set spantree bridgeprioritymode

Use this command to set the Spanning Tree bridge priority mode to 802.1D (legacy) or 802.1t.
Syntax
set spantree bridgeprioritymode {8021d | 8021t}
7-10 Spanning Tree Configuration