Show Spantree Vlanlist; Show Spantree Mstcfgid - Enterasys SecureStack C2 Configuration Manual

show spantree vlanlist

Use this command to display the Spanning Tree ID(s) assigned to one or more VLANs.
Syntax
show spantree vlanlist [vlan-list]
Parameters
vlan‐list
Defaults
If not specified, SID assignment will be displayed for all VLANs.
Mode
Switch command, read‐only.
Example
This example shows how to display the SIDs mapped to VLAN 1. In this case, SIDs 2, 16 and 42
are mapped to VLAN 1. For this information to display, the SID instance must be created using
the set spantree msti command as described in "set spantree msti" on page 7‐12, and the FIDs
must be mapped to SID
mstmap" on page 7‐14:
C2(su)->show spantree vlanlist 1
The following SIDS are assigned to VLAN 1: 2 16 42

show spantree mstcfgid

Use this command to display the MST configuration identifier elements, including format selector,
configuration name, revision level, and configuration digest.
Syntax
show spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the MST configuration identifier elements. In this case, the
default revision level of 0, and the default configuration name (a string representing the bridge
MAC address) have not been changed. For information on using the set spantree mstcfgid
command to change these settings, refer to "set spantree mstcfgid" on page 7‐16:
(Optional) Displays SIDs assigned to specific VLAN(s).
1 using the set spantree mstmap command as described in "set spantree
show spantree vlanlist
SecureStack C2 Configuration Guide 7-15