Set Snmp Community - Enterasys SECURESTACK C3 Configuration Manual

set snmp community

Mode
Switch command, read‐only.
Example
This example shows how to display information about the SNMP "public" community name. For
a description of this output, refer to set snmp community (page 8‐14).
C3(su)->show snmp community public
--- Configured community strings ---
Name
Security name
Context
Transport tag
Storage type
Status
set snmp community
Use this command to configure an SNMP community group.
Syntax
set snmp community community [securityname securityname] [context context]
[transport transport] [volatile | nonvolatile]
Parameters
community
securityname
securityname
context context
transport transport
volatile |
nonvolatile
Defaults
If securityname is not specified, the community name will be used.
If context is not specified, the default (NULL) context is applied.
If transport tag is not specified, none will be applied.
If storage type is not specified, nonvolatile will be applied.
Mode
Switch command, read‐write.
8-14 SNMP Configuration
= *********
= public
=
=
= nonVolatile
= active
Specifies a community group name.
(Optional) Specifies an SNMP security name to associate with this
community.
(Optional) Specifies a subset of management information this community
will be allowed to access. Valid values are full or partial context names. To
review all contexts configured for the device, use the show snmp context
command as described in "show snmp context" on page 8‐21.
(Optional) Specifies the set of transport endpoints from which SNMP
request with this community name will be accepted. Makes a link to a
target address table.
(Optional) Specifies the storage type for these entries.