Set Lacp; Set Lacp Asyspri - Enterasys SecureStack C2 Configuration Manual

Table 5-6 show lacp Output Details (Continued)
Output
System Priority
Admin Key
Oper Key
Attached Ports

set lacp

Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
Syntax
set lacp {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable LACP:
C2(su)->set lacp disable

set lacp asyspri

Use this command to set the LACP system priority.
Syntax
set lacp asyspri value
What It Displays...
System priority value which determines aggregation precedence. Only one LACP
system priority can be set on a SecureStack C2 device, using either the set lacp
asyspri command (page 5-37), or the set port lacp command
Port's assigned key. SecureStack C2 devices provide a default admin key value of
32768 for all LAG ports (lag.0.1 though lag.0.6).
Port's operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator's will be allowed to aggregate.
Underlying physical ports associated with this aggregator.
Disables or enables LACP.
(page 5-43)
SecureStack C2 Configuration Guide 5-37
set lacp
.