Set Linkflap Globalstate; Show Linkflap Metrics Output Details - Enterasys SecureStack B3 Configuration Manual

set linkflap globalstate

This example shows how to display the link flap metrics table:
B3(rw)->show linkflap metrics
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 5‐4 provides an explanation of the show linkflap metrics command output.
Table 5-4 show linkflap metrics Output Details
Output...
Port
LinkStatus
CurrentCount
TotalCount
TimeElapsed
Violations
set linkflap globalstate
Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
disable | enable
Defaults
By default, the function is disabled globally and on all ports.
Mode
Switch mode, read‐write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per‐port
settings have been configured using the linkflap commands, per‐port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
B3(rw)->set linkflap globalstate enable
5-22 Port Configuration
LinkStatus CurrentCount
----------- ------------
operational 0
disabled 4
operational 3
Globally disables or enables the link flap detection function.
TotalCount TimeElapsed
---------- ----------- -------------
0 241437
15 147
3 241402
What it displays...
Port designation.
Link status according to the link flap function.
Link down count accruing toward the link flap threshold.
Number of link downs since system start,
Time (in seconds) since the last link down event.
Number of link flap violations on listed ports since system start.
Violations
0
5
0