Show Port Counters; Show Port Status Output Details - Enterasys SecureStack C2 Configuration Manual
Stackable switches
Hide thumbs
Also See for SecureStack C2:
- Configuration manual (698 pages) ,
- Installation manual (34 pages)
Table of Contents
Advertisement
Table 5-1 show port status Output Details
Output
Port
Alias (truncated)
Oper Status
Admin Status
Speed
Duplex
Type
show port counters
Use this command to display port counter statistics detailing traffic through the device and
through all MIB2 network devices.
Syntax
show port counters [port-string] [switch | mib2]
Parameters
port‐string
switch | mib2
Defaults
If port‐string is not specified, counter statistics will be displayed for all ports.
If mib2 or switch are not specified, all counter statistics will be displayed for the specified port(s).
Mode
Switch command, read‐only.
What It Displays...
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Alias configured for the port. For details on using the set port alias command, refer
to
"set port
alias" on page 5-8.
Operating status (up or down).
Whether the specified port is enabled (up) or disabled (down). For details on using
the set port disable command to change the default port status of enabled, refer to
"set port
disable" on page 5-7. For details on using the set port enable command to
re-enable ports, refer to
"set port
Operational speed in Mbps or Kbps of the specified port. For details on using the set
port speed command to change defaults, refer to
Duplex mode (half or full) of the specified port. For details on using the set port
duplex command to change defaults, refer to
Advertised
Ability" on page 5-14.
Physical port and interface type.
(Optional) Displays counter statistics for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 5‐2.
(Optional) Displays switch or MIB2 statistics. Switch statistics detail
performance of the SecureStack C2 device. MIB2 interface statistics detail
performance of all network devices.
CLI" on page 5-2.
enable" on page 5-7.
"set port
"Setting Auto-Negotiation and
SecureStack C2 Configuration Guide 5-5
show port counters
speed" on page 5-10.
Advertisement
Table of Contents
