Set Ciscodp Status; Set Ciscodp Timer; Show Ciscodp Port Info Output Details - Enterasys SECURESTACK C3 Configuration Manual

Table 6-3 show ciscodp port info Output Details
Output Field
Port
State
vvid
trusted
cos

set ciscodp status

Use this command to enable or disable the Cisco discovery protocol globally on the switch.
Syntax
set ciscodp state {auto | disable | enable}
Parameters
auto
disable
enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally enable CiscoDP:
C3(su)->set ciscodp state enable

set ciscodp timer

Use this command to set the number of seconds between Cisco discovery protocol PDU
transmissions.
Syntax
set ciscodp timer seconds
What It Displays...
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the set ciscodp port command.
Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the set ciscodp port command.
The trust mode of the port. Default of trusted can be changed using the set ciscodp
port command.
The Class of Service priority value for untrusted traffic. The default of 0 can be
changed using the set ciscodp port command.
Globally enable only if Cisco DP PDUs are received.
Globally disable Cisco discovery protocol.
Globally enable Cisco discovery protocol.
CLI" on page 7-1.
SecureStack C3 Configuration Guide 6-9
set ciscodp status