Ip Igmp Querier - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ip igmp querier

Syntax
Release Information
Description
Mode
824
[ no ] ip igmp querier
Command introduced before JunosE Release 7.1.0.
Specifies that the interface will act as a querier when you configure IGMPv1 on an interface;
this is the default behavior. The no version specifies that this interface will not issue query
packets.
NOTE: This command is valid only for interfaces on configured with IGMPv1.
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.