Ip Igmp Querier - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip igmp querier
Syntax
Release Information
Description
Mode
824
[ no ] ip igmp querier
Command introduced before JunosE Release 7.1.0.
Specifies that the interface will act as a querier when you configure IGMPv1 on an interface;
this is the default behavior. The no version specifies that this interface will not issue query
packets.
NOTE: This command is valid only for interfaces on configured with IGMPv1.
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers