Ip Vrrp Icr-Partition - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip vrrp icr-partition

Syntax
Release Information
Description
Options
Mode
Related Topics
972
[ no ] ip vrrp vrid icr-partition partitionId
Command introduced in JunosE Release 10.3.0.
Creates an ICR partition that corresponds to the VRRP instance. The state of the ICR
partition depends on the state of the VRRP instance. If the VRRP instance is disabled,
the ICR partition is in the dormant state. If the VRRP instance is enabled, the ICR partition
follows the state of the VRRP instance. The no version deletes the partition from the
router.
vrid—VRID identifier; a number in the range 1–255
partitionId—Name that identifies the ICR partition; a string of up to 128 alphanumeric
characters
NOTE: Use the ICR-Partition-Id VSA to determine the ICR partition on which subscribers
are logged in. You can configure the same ICR-Partition-Id string for an active ICR
partition and its corresponding backup partition. For more information on
ICR-PArtition-ID VSA, see Interaction with RADIUS for ICR.
Interface Configuration, Subinterface Configuration
Naming ICR Partitions
Configuring an ICR Partition
Copyright © 2010, Juniper Networks, Inc.