[26-150] Icr-Partition-Id; All Ipv6 Accounting Attributes - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
radius include icr-partition-id
radius icr-partition-accounting
radius include ipv6-accounting
224
Example 2—Accepts the Max-Clients-Per-Interface attribute returned by the RADIUS
server
host1(config)#radius ignore pppoe-max-session disable
When you issue this command, the router passes the value of the
Max-Clients-Per-Interface attribute to the PPP application. PPP, in turn, sends this
value to the PPPoE application, which determines whether or not to tear down the
PPPoe interface based on the maximum session limit for this subscriber.
Use the no version to restore the default, enable.

[26-150] ICR-Partition-Id

Use the following commands to manage the ICR-Partition-Id RADIUS attribute.
radius include icr-partition-id
radius icr-partition-accounting
Use to include the ICR-Partition-Id attribute in Access-Request, Acct-Start, or Acct-Stop
messages.
You can control inclusion of the attribute by enabling or disabling this command.
Example
host1(config)#radius include icr-partition-id acct-start enable
Use the no version to restore the default, disable.
Use to enable or disable sending of the ICR Partition-Accounting-On or
Partition-Accounting-Off messages to the RADIUS servers
Both Partition-Accounting messages include the ICR-Partition-Id VSA. Also, both these
messages are sent to the RADIUS accounting server configured on the virtual router
where the ICR partition is configured or the virtual router on which the ICR control
interface is set up.
You can configure ICR partition accounting per virtual router.
Example
host1(config)#radius icr-partition-accounting enable
Use the no version to restore the default, disable.

All IPv6 Accounting Attributes

Use the following command to manage all IPv6 accounting attributes:
radius include ipv6-accounting
Copyright © 2010, Juniper Networks, Inc.