Ip Dvmrp Enable; Ip Dvmrp Metric - Enterasys SecureStack C2 Configuration Manual

ip dvmrp enable

Syntax
ip dvmrp
no ip dvmrp
Parameters
None.
Defaults
None.
Mode
Global configuration: C2(su)‐>router(Config)#
Example
This example shows how to enable the DVMRP process:
C2(su)->router(Config)#ip dvmrp
ip dvmrp enable
Use this command to enable DVMRP on an interface. The no form of this command disables
DVMRP on an interface:
Syntax
ip dvmrp enable
no ip dvmrp enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to enable DVMRP on the VLAN 1 interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip dvmrp enable

ip dvmrp metric

Use this command to configure the metric associated with a set of destinations for DVMRP
reports.
Syntax
ip dvmrp metric metric
17-32 IPv4 Routing Protocol Configuration
(su)‐>router(Config‐if(Vlan 1))#