Bridge-Group - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

bridge-group

bridge-group { bridgeGroupName | vplsName }
Syntax
[ subscriber-trunk | snmp-trap link-status | learn addressCount ]
no bridge-group { bridgeGroupName | vplsName } [ subscriber-trunk | snmp-trap
link-status | learn ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
vplsName variable added in JUNOSe Release 7.1.0.
Assigns a network interface to a bridge group or VPLS instance. You can also use
Description
this command to configure the type of interface, enable SNMP link-status processing
for the interface, and set the maximum number of dynamic MAC addresses that the
interface can learn. The no version removes the network interface from the bridge
group or VPLS instance and restores the default values for the interface type
(subscriber client interface), SNMP link-status processing (disabled), or number of
maximum learned MAC addresses (0 addresses).
Options
Interface Configuration, Subinterface Configuration
Mode
Related Topics
318
bridge-group
bridgeGroupName Name of the bridge group to which the interface belongs, as
specified with the bridge command
vplsName Name of the VPLS instance to which the interface belongs, as specified
with the bridge vpls transport-virtual-router command
subscriber-trunk Creates a trunk (server) interface in the bridge group or VPLS
instance; if you omit this keyword, the router creates a subscriber (client) interface
by default
snmp-trap link-status Enables SNMP link-status processing only for the specified
interface in the bridge group or VPLS instance
addressCount Maximum number of MAC addresses that the interface in the
bridge group or VPLS instance can learn, up to the maximum number that the
router supports, in the range 0–64000
Configuring VPLS Network Interfaces in the JUNOSe BGP and MPLS Configuration
Guide