Chapter 3: B Commands
bridge crb
[ no ] bridge crb
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables concurrent routing and bridging (CRB) for all bridge groups configured on
Description
the router except those bridge groups configured as VPLS instances. When CRB is
enabled, the router can route a protocol among a group of interfaces in one bridge
group and concurrently bridge the same protocol among a separate group of interfaces
in a different bridge group on the router. The no version disables CRB on all bridge
groups and restores the default bridging capability.
The command takes effect for all bridge groups on the router not configured as VPLS
instances; you cannot enable CRB for some bridge groups but not for others.
Global Configuration
Mode
317
bridge crb