Baseline Frame-Relay Interface - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

baseline frame-relay interface

baseline frame-relay interface interfaceType interfaceSpecifier [ dlci ]
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets a statistics baseline for Frame Relay and MLFR interfaces, subinterfaces, and
Description
circuits. The router implements the baseline by reading and storing the statistics at
the time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved. There is no no version.
Options
Privileged Exec
Mode
interfaceType One of the following interface types listed in Interface Types and
Specifiers on page 5
mlframe-relay
pos
serial
tunnel
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
dlci—DLCI number to be used on the specified subinterface to identify a virtual
circuit in the range 16–1007
Chapter 3: B Commands
baseline frame-relay interface
225