Interface Atm - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

Software for e series broadband services routers command reference a to m
Hide thumbs Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
Table of Contents

Advertisement

interface atm

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
[ no ] interface atm interfaceSpecifier [ multipoint | point-to-point ]
Command introduced before JunosE Release 7.1.0.
Configures an ATM interface or subinterface type. The no version removes the interface
or subinterface.
NOTE: On the OC3-2 GE APS I/O module, you can configure only OC3/STM1 ATM
interfaces in ports 0 and 1. Port 2 is reserved for a Gigabit Ethernet interface.
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
multipoint—Specifies an NBMA subinterface
point-to-point—Specifies an ATM interface or subinterface; default
Global Configuration, Interface Configuration
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation, Configuring Local
ATM Cross-Connects with AAL5 Encapsulation, and Configuring MPLS LSPs for L2VPNs
in the JunosE BGP and MPLS Configuration Guide
Chapter 10: I Commands
713

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents