Bridge Vpls Site-Range - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

bridge vpls site-range

bridge vplsName vpls site-range siteRange
Syntax
no bridge vplsName vpls site-range
Command introduced in JUNOSe Release 7.1.0.
Release Information
Configures the maximum number of customer sites that can participate in the
Description
specified VPLS domain that uses BGP as the signaling protocol. In a VPLS
configuration, each customer site is represented by a customer edge (CE) device
located at the edge of the customer's network. The router (VPLS edge device)
communicates with the customer site by means of a bridge network interface
connection to the CE device. The no version restores the default site range, 1.
The bridge vpls site-range command is not valid for a VPLS instance that uses LDP
as the signaling protocol. To configure a VPLS instance with LDP signaling, use the
mpls ldp vpls vpls-id command and the mpls ldp vpls neighbor command.
NOTE: The bridge vpls site-range command is available for a VPLS instance only
after you issue the bridge vpls transport-virtual-router command, which creates the
VPLS instance and configures the transport virtual router.
Options
Global Configuration
Mode
Related Topics
328
bridge vpls site-range
vplsName Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
siteRange Maximum number of sites that can participate in the VPLS domain,
in the range 1–65534; default value is 1
Configuring VPLS Instances with BGP Signaling in the JUNOSe BGP and MPLS
Configuration Guide