Bgp Cluster-Id - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

bgp cluster-id

bgp cluster-id { clusterId | ipAddress }
Syntax
no bgp cluster-id [ clusterId | ipAddress ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures a cluster ID if the BGP cluster has more than one route reflector. The no
Description
version causes BGP to use the router ID as the cluster ID.
Options
Router Configuration
Mode
clusterId—Number in the range 0–4294967295; the cluster ID of this router
acting as a route reflector
ipAddress—Cluster ID of this router acting as a route reflector specified as an IP
address
Chapter 3: B Commands
281
bgp cluster-id